BRAND GATE
NanoHARD is a multifunctional programmable AEG Controller.
It has 8 functions. Thanks to its special coating, it is resistant to atmospheric
conditions (Military Specification MIL-V-173C).
Battery protection supports: Li-Po 7.4V / 11.1V / 14.8V.
You can also disable the protection and use other batteries.
Included in the kit:
Additional kit of Deans-T Connectors
Single signal wire for trigger contacts
Double signal wire for trigger contacts
Programming button
Jumper (2pcs.)
ON/OFF ACTIVE BRAKE
This is the first controller that provides you with the possibility to turn off the
Active Brake. You can enable or disable the Active Brake at any time.
SMART FUSE
The new AEG Controller should never let you down on the battle field. It is the best
electronic fuse that has ever been made. This is the first AEG Controller with a true
current sensor. A combination of current, voltage and temperature measurements
provides your AEG installation with the high reliability. If your rifle becomes jammed, it
protects motor and battery against any damage. There is no known way to destroy the
controller by overheating, overloading or short-circuiting of the electrical system.
BUILT-IN SELF-TEST
It allows you to quickly check whether the AEG Controller works properly. If you have
problems with your AEG, the BUILT-IN SELF-TEST allows you to check that the
problem is not caused by the controller.
MOSFET
Do you want to achieve higher rate of fire and faster trigger response? Are you planning
power upgrade of your rifle? In that case, you need a MOSFET.
It targets the energy from the battery directly to the motor, bypassing the mechanical
trigger contacts. As a result, you gain a higher rate of fire of the rifle and faster trigger
response, and the contacts are protected against burn out.
PROTECTION AGAINST OVER-DISCHARGE OF BATTERY
Modern LiPoly batteries are very sensitive to over-discharge. If you do not want to
damage the battery and you care about its service life, this protection is indispensable.
The microprocessor constantly monitors the battery voltage. When it drops down to a
critical level, it will not permit firing.
DEBOUNCING
This provides full compatibility with the micro-switches. It is fully resistant to contact
bounce. You gain a bigger ROF, a faster trigger response and your MOSFET is less
prone to heating.
14.8V LI-PO READY
The system can be used with batteries up to LI-PO 14.8V. Minimum operating
voltage is 3V and maximum voltage is 17V.
COATING
Thanks to its special coating, it is resistant to atmospheric conditions
(Military Specification MIL-V-173C).
Free shipping for orders over 800€!
Data sheet
Description
GATE-NHARD
-
Shipping of goods in 24 hours
-
Product availability updated in real time
-
Secure payments by credit card, Pay Pal and cash on delivery
Featured
Reviews from our customers
Comments (0)
error Your review appreciation cannot be sent
feedback Report comment
Are you sure that you want to report this comment?
check_circle Report sent
Your report has been submitted and will be considered by a moderator.
error Your report cannot be sent
Write your review
check_circle Review sent
Your comment has been submitted and will be available once approved by a moderator.
error Your review cannot be sent
In the same category
Vip Club
Load more
Our clothing proposal
Load more